| View previous topic :: View next topic |
| Author |
Message |
Robert Hyatt
Joined: 27 Feb 2006 Posts: 15819 Location: Birmingham, AL
|
Post subject: Re: Cutting power by software - what device do i need? Posted: Tue Mar 20, 2012 4:45 am |
|
|
| diep wrote: |
| Adam Hair wrote: |
Is it possible to control an individual usb port? If so, then you could use a usb controlled power strip. It monitors the 5 volt usb output and shuts down when the voltage ceases.
If not, then you might have to do what Bob suggested. Get a usb relay, and use that to control the power to an intermediate receptacle outlet which you plug the switch into. I found one here that is not too expensive:
http://www.pencomdesign.com/1ch_usb_relay.htm |
I'm not such a fan of USB. Actually the motherboards have a com port, RS232, so maybe i can use some old fashioned thing there.
Same principle applies then i suppose.
Usually in bios i turn off usb entirely - too easy to hack machines that have usb enabled.
Now i want to control of course the fans of the switch, the next thing to also monitor is the fans i intend to build to blow air in and out of the room, though i have some months for that to go when it gets a tad hotter and it has to lose the cluster heat to outside - that will be a lot easier to control though and probably no relays needed as just have to shutdown the machines then.
p.s. the relays you advice seems a windoze only relay - not gonna work at linux here  |
I have seen RS232 to USB and such scattered around over the years, although it might be less common today... |
|
| Back to top |
|
 |
|
| Subject |
Author |
Date/Time |
Cutting power by software - what device do i need? |
Vincent Diepeveen |
Mon Mar 19, 2012 8:54 am |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Mon Mar 19, 2012 4:46 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Mon Mar 19, 2012 6:06 pm |
Re: Cutting power by software - what device do i need? |
J. Wesley Cleveland |
Mon Mar 19, 2012 6:19 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Mon Mar 19, 2012 8:05 pm |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Mon Mar 19, 2012 11:36 pm |
Re: Cutting power by software - what device do i need? |
Ben-Hur Carlos Langoni |
Mon Mar 19, 2012 8:54 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Mon Mar 19, 2012 9:27 pm |
Re: Cutting power by software - what device do i need? |
Ronald de Man |
Mon Mar 19, 2012 10:27 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Mon Mar 19, 2012 11:15 pm |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Mon Mar 19, 2012 11:37 pm |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Mon Mar 19, 2012 11:27 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 12:00 am |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Tue Mar 20, 2012 12:22 am |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 12:40 am |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Tue Mar 20, 2012 1:15 am |
Re: Cutting power by software - what device do i need? |
Adam Hair |
Tue Mar 20, 2012 2:05 am |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 2:39 am |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 2:40 am |
Re: Cutting power by software - what device do i need? |
Adam Hair |
Tue Mar 20, 2012 2:22 am |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 2:48 am |
Re: Cutting power by software - what device do i need? |
Robert Hyatt |
Tue Mar 20, 2012 4:45 am |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Tue Mar 20, 2012 12:31 pm |
Re: Cutting power by software - what device do i need? |
Ben-Hur Carlos Langoni |
Tue Mar 20, 2012 2:49 pm |
Re: Cutting power by software - what device do i need? |
Vincent Diepeveen |
Wed Mar 21, 2012 12:17 pm |
|
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
|
|