Myracle GUI

[vencenda]

Thanks again for the amazing program, and for EPD support specifically. The advanced tournament edit is very helpful too. I really think the community will appreciate your GUI.

[Modern Times]

Quick question. If I want to run a gauntlet, with the gauntlet engine playing 100 openings against each opponent with reversed side, what are the setting for that ? Is it:
Cycles = 100 and "repeat reverse" ticked ?
Or is it "repeat openings"

I'm not clear on this.

In cutechess it is:
Rounds 100
Games per encounter 2
Play each opening 2 times
Swap sides ticked

thanks

[Mark 1]

Hello Martin...

I may have discovered a bug. When you select an EPD file under *New Game* and click *OK*, error messages about illegal moves appear. In a tournament with multiple engines, however, everything works fine. Can you reproduce this on your side.

Best regards
Mark 1

[vencenda]

Small bug (I think):
If you have overridden engines' options for threads and hash in a tournament, when you hover over the engine's name during a tournament game, in the status bar it shows the cores/hash from the engine's settings, instead of the cores/hash used right now.

[Modern Times]

Quick question. If I want to run a gauntlet, with the gauntlet engine playing 100 openings against each opponent with reversed side, what are the setting for that ? Is it:
Cycles = 100 and "repeat reverse" ticked ?
Or is it "repeat openings"

I'm not clear on this.

thanks

It doesn't seem to be this:
gauntlet
Cycles = 100
"repeat reverse" ticked
3 engines selected

I should get 400 games
Engine 1 vs Engine 2 100 openings reversed sides = 200
Engine 1 vs Engine 3 100 openings reversed sides = 200

but it says only 200 games will be played.

[Wilhelm]

Hello Martin,
many thanks for this cool GUI, I realy like this clean look!
I have one question: is it possible to add the solving times and the average solving time when running an epd test suite? This would be an important feature.
Thank you!

regards
William

[F.Huber]

Question for the GUI author. Is it possible to remove or make these three tabs invisible?

If you keep bothering here, Martin will probably add a fourth tab specifically for you.

[Ras]

Question for the GUI author. Is it possible to remove or make these three tabs invisible?

Moderation: Krzysztof, stop spamming the thread with this question. You have asked that over and over already.

[Mark 1]

Thx Ras !

[mar]

Quick question. If I want to run a gauntlet, with the gauntlet engine playing 100 openings against each opponent with reversed side, what are the setting for that ? Is it:
Cycles = 100 and "repeat reverse" ticked ?
Or is it "repeat openings"

I'm not clear on this.

thanks

It doesn't seem to be this:
gauntlet
Cycles = 100
"repeat reverse" ticked
3 engines selected

I should get 400 games
Engine 1 vs Engine 2 100 openings reversed sides = 200
Engine 1 vs Engine 3 100 openings reversed sides = 200

but it says only 200 games will be played.

repeat reverse is the right checkbox to tick, repeat openings means all engines will use the same opening each round, this is not the first time it causes a confusion

the repeat reverse doesn't add new games, it simply forces to repeat the same opening with reversed colors each other cycle, it works a bit different from cutechess, there's no games per encounter

so in your case, assuming a gauntlet: you have 1 seed and 2 opponents, each cycle the seed plays 2 opponents,
so after 100 cycles you get 200 games
if you want 400 games you have to double the cycles to 200 in this case; the setup always shows the number of games and rounds
to be played to make it easier