How many kNodes/sec (average) can your computer count?

[vittyvirus]

Here's my laptop (Vaio Vpceh28fn) config:
Processors
-------------------------------------------------------------------------

Number of processors 1
Number of threads 4

APICs
-------------------------------------------------------------------------

Processor 0
-- Core 0
-- Thread 0 0
-- Thread 1 1
-- Core 1
-- Thread 0 2
-- Thread 1 3

Timers
-------------------------------------------------------------------------

ACPI timer 3.580 MHz
HPET timer 14.318 MHz
Perf timer 2.338 MHz
Sys timer 1.000 KHz
BCLK timer 99.77 MHz


Processors Information
-------------------------------------------------------------------------

Processor 1 ID = 0
Number of cores 2 (max 8)
Number of threads 4 (max 16)
Name Intel Core i5 2430M
Codename Sandy Bridge
Specification Intel(R) Core(TM) i5-2430M CPU @ 2.40GHz
Package (platform ID) Socket 988B rPGA (0x4)
CPUID 6.A.7
Extended CPUID 6.2A
Core Stepping D2
Technology 32 nm
TDP Limit 35 Watts
Core Speed 798.2 MHz
Multiplier x Bus Speed 8.0 x 99.8 MHz
Stock frequency 2400 MHz
Instructions sets MMX, SSE, SSE2, SSE3, SSSE3, SSE4.1, SSE4.2, EM64T, VT-x, AES, AVX
L1 Data cache 2 x 32 KBytes, 8-way set associative, 64-byte line size
L1 Instruction cache 2 x 32 KBytes, 8-way set associative, 64-byte line size
L2 cache 2 x 256 KBytes, 8-way set associative, 64-byte line size
L3 cache 3 MBytes, 12-way set associative, 64-byte line size
FID/VID Control yes


Turbo Mode supported, enabled
Max non-turbo ratio 24x
Max turbo ratio 30x
Max efficiency ratio 8x
Max Power 56 Watts
Min Power 24 Watts
O/C bins none
Ratio 1 core 30x
Ratio 2 cores 28x
Ratio 3 cores 28x
Ratio 4 cores 28x
TSC 2394.6 MHz
APERF 2599.8 MHz
MPERF 2390.6 MHz

Chipset
-------------------------------------------------------------------------

Northbridge Intel Sandy Bridge rev. 09
Southbridge Intel HM65 rev. B2
Graphic Interface PCI-Express
PCI-E Link Width x16
PCI-E Max Link Width x16
Memory Type DDR3
Memory Size 4 GBytes
Channels Single
Memory Frequency 665.2 MHz (1:5)
CAS# latency (CL) 9.0
RAS# to CAS# delay (tRCD) 9
RAS# Precharge (tRP) 9
Cycle Time (tRAS) 24
Command Rate (CR) 1T
MCHBAR I/O Base address 0x0FED10000
MCHBAR I/O Size 19456
MCHBAR registers

Memory SPD
-------------------------------------------------------------------------

DIMM # 1
SMBus address 0x50
Memory type DDR3
Module format SO-DIMM
Manufacturer (ID) Samsung (CE00000000000000)
Size 4096 MBytes
Max bandwidth PC3-10700 (667 MHz)
Part number M471B5273DH0-CH9
Serial number 945C09A2
Manufacturing date Week 31/Year 11
Number of banks 8
Nominal Voltage 1.50 Volts
EPP no
XMP no
AMP no
--------------------------------------------------------------------------------------
I get 4100 kNodes/sec on Houdini 4 Pro but a relatively very low 1344 Knodes on stockfish DD.

[Vinvin]

If you want to compare, there are some benchmarks here : http://www.sedatcanbaz.com/chess/?page_id=381

[vittyvirus]

If you want to compare, there are some benchmarks here : http://www.sedatcanbaz.com/chess/?page_id=381

I just to see how powerful the computers of talkchess community are.. So what's your kNodes/sec average?

[Vinvin]

If you want to compare, there are some benchmarks here : http://www.sedatcanbaz.com/chess/?page_id=381

I just to see how powerful the computers of talkchess community are.. So what's your kNodes/sec average?

I benched 8 config here : http://www.sedatcanbaz.com/chess/?page_id=19

[vittyvirus]

If you want to compare, there are some benchmarks here : http://www.sedatcanbaz.com/chess/?page_id=381

I just to see how powerful the computers of talkchess community are.. So what's your kNodes/sec average?

I benched 8 config here : http://www.sedatcanbaz.com/chess/?page_id=19

thabk you